Hydraulic valves can break down, regardless of how reliable or well-made they may be. A damaged valve is problematic because it can stop a hydraulic system from operating, so if you ever encounter this problem, you need to find a suitable solution right away. If you’re not sure whether you should repair or replace your hydraulic valve, the following guide will help you figure out which option is best.
Repairing a valve is generally more cost-effective because repairs tend to cost less than the purchase of a brand new valve. If you notice that only a part of your valve is faulty, you should look into repairs as this would be more affordable and takes less time than a replacement. Hydraulic valves can sometimes experience premature failure caused by minor reasons, and if most of the other parts are fine, the valve can survive and can continue to work if you complete the necessary repairs. In these instances, repairing it would be your best option, so weigh the situation and assess the extent and type of damage. Remember that valves can fail for different reasons and it can be something as small as a faulty screw, so the issue is not always serious.
Technicians can disassemble your valve and will clean it so that they can do a thorough inspection. This will allow them to see what the problem is and the issue may be something simple like replacing the soft seals. Opening up the valve for repairs allows technicians to spot any components that are failing or ones that may fail so that they can be fixed.
If your hydraulic valve is badly damaged and has experienced a lot of wear and tear, replacing it would be the best option. If multiple parts of the valve are damaged, it would be more expensive to have each of them individually repaired, and replacing the whole thing would cost less. Additionally, if some of the undamaged parts of the valve are too expensive to manufacture individually, it may be cheaper to replace the entire valve, so you need to consider the entire situation. Old valves and ones that have been used extensively can fail and if this keeps happening, it would be best to look into a replacement. This is especially true if the valve keeps failing for different reasons because repairing each part individually would cost a lot more in the long run than if you had simply replaced the whole valve from the start.
Essentially, you need to assess the situation because both repairs and a replacement can be expensive. If the valve can be repaired, you wouldn’t want to spend money on a new one but you also wouldn’t want to keep paying for repairs because these costs can add up and, in some cases, can end up costing more than replacing the entire valve.
If you need a hydraulic repair service, GO Hydraulics can help. Whether you need cylinder or pump repairs, we do it all, so contact us today!